Re: [Qemu-discuss] RPM for 3.1.0

[stecdose]

I just compiled qemu-3.1.0 this day on debian sid, works without 
problems so far...

How did you test? Did you just use a binary-distribution not targeted at 
your OS or did you compile from source? Which targets i386? arm? ...?

Such a misbehaviour is very serious if it is caused by a program. I 
don't want to blame you, but I suspect something went wrong before you 
started qemu-system-... that SIGSEGVed...

Greets,

Nils

On 12/23/18 9:11 PM, Dennis Clarke wrote:
> On 12/23/18 11:56 AM, Mahmood Naderan wrote:
> > Hi,
> > How can I get the RPM for qemu-3.1.0? In the website it is stated 
> > that the command is "yum install qemu-kvm" however, that is pretty 
> > old for Centos 7.
> > Any idea?
>
>     To be honest I have seen no evidence that 3.1.0 works on Debian or
> FreeBSD or anywhere else I have tested.  For reasons unknown it merely
> SIGSEGV faults and at best I see guest machines attempt to boot and then
> throw many many errors before the SIGSEGV.
>
>     It may be best to wait until that final digit zero revs up with some
> patches and fixes.
>
> Dennis