qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] [RFCv2 for-4.0 1/5] virtio-balloon: Remove unnecessary MADV


From: David Gibson
Subject: [Qemu-devel] [RFCv2 for-4.0 1/5] virtio-balloon: Remove unnecessary MADV_WILLNEED on deflate
Date: Wed, 5 Dec 2018 16:06:37 +1100

When the balloon is inflated, we discard memory place in it using madvise()
with MADV_DONTNEED.  And when we deflate it we use MADV_WILLNEED, which
sounds like it makes sense but is actually unnecessary.

The misleadingly named MADV_DONTNEED just discards the memory in question,
it doesn't set any persistent state on it in-kernel; all that's necessary
to bring the memory back is to touch it.  MADV_WILLNEED in contrast
specifically says that the memory will be used soon and faults it in.

This patch simplify's the balloon operation by dropping the madvise()
on deflate.  This might have an impact on performance - it will move a
delay at deflate time until that memory is actually touched, which
might be more latency sensitive.  However:

  * Memory that's being given back to the guest by deflating the
    balloon *might* be used soon, but it equally could just sit around
    in the guest's pools until needed (or even be faulted out again if
    the host is under memory pressure).

  * Usually, the timescale over which you'll be adjusting the balloon
    is long enough that a few extra faults after deflation aren't
    going to make a difference.

Signed-off-by: David Gibson <address@hidden>
Reviewed-by: David Hildenbrand <address@hidden>
Reviewed-by: Michael S. Tsirkin <address@hidden>
---
 hw/virtio/virtio-balloon.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/hw/virtio/virtio-balloon.c b/hw/virtio/virtio-balloon.c
index 1728e4f83a..6ec4bcf4e1 100644
--- a/hw/virtio/virtio-balloon.c
+++ b/hw/virtio/virtio-balloon.c
@@ -35,9 +35,8 @@
 
 static void balloon_page(void *addr, int deflate)
 {
-    if (!qemu_balloon_is_inhibited()) {
-        qemu_madvise(addr, BALLOON_PAGE_SIZE,
-                deflate ? QEMU_MADV_WILLNEED : QEMU_MADV_DONTNEED);
+    if (!qemu_balloon_is_inhibited() && !deflate) {
+        qemu_madvise(addr, BALLOON_PAGE_SIZE, QEMU_MADV_DONTNEED);
     }
 }
 
-- 
2.19.2




reply via email to

[Prev in Thread] Current Thread [Next in Thread]