[Qemu-devel] [RFC v1 00/23] Add RISC-V TCG backend support

[Alistair Francis]

This patch set adds RISC-V backend support to QEMU. This is based on
Michael Clark's original work with some patches ontop.

This has been slightly tested and can run other architecture softmmu
code for a number of instructions but eventually QEMU will either
seg fault or generate an illigal instruction (depending on the guest
architecture).

I haven't tested linux user support at all yet. I think Michael had that
working reliably though and hopefully my changes haven't broken it. I'll
test both a lot more before I send a full patchset.

My hope of submitting an RFC is that some extra eyes on the code might
help catch what is wrong. Comparing the guest CPU state to a working
version hasn't given any hints as the states match, even up until the
generated code segfaults.

This branch can be found here:
https://github.com/alistair23/qemu/tree/mainline/alistair/tcg-backend-upstream.next

The working version with Michael's orignal patch and work ontop can be
found here:
https://github.com/alistair23/qemu/tree/mainline/alistair/tcg-backend.next


Alistair Francis (23):
  elf.h: Add the RISCV ELF magic numbers
  linux-user: Add host dependency for RISC-V 32-bit
  linux-user: Add host dependency for RISC-V 64-bit
  exec: Add RISC-V GCC poison macro
  riscv: Add the tcg-target header file
  riscv: Add the tcg target registers
  riscv: tcg-target: Regiser the JIT
  riscv: tcg-target: Add support for the constraints
  riscv: tcg-target: Add the immediate encoders
  riscv: tcg-target: Add the instruction emitters
  riscv: tcg-target: Add the relocation functions
  riscv: tcg-target: Add the mov and movi instruction
  riscv: tcg-target: Add the extract instructions
  riscv: tcg-target: Add the out load and store instructions
  riscv: tcg-target: Add branch and jump instructions
  riscv: tcg-target: Add slowpath load and store instructions
  riscv: tcg-target: Add direct load and store instructions
  riscv: tcg-target: Add the out op decoder
  riscv: tcg-target: Add the prologue generation
  riscv: tcg-target: Add the target init code
  tcg: Add RISC-V cpu signal handler
  dias: Add RISC-V support
  configure: Add support for building RISC-V host

 accel/tcg/user-exec.c             |   48 +
 configure                         |   12 +-
 disas.c                           |   10 +-
 include/elf.h                     |   55 +
 include/exec/poison.h             |    1 +
 linux-user/host/riscv32/hostdep.h |   11 +
 linux-user/host/riscv64/hostdep.h |   11 +
 tcg/riscv/tcg-target.h            |  173 +++
 tcg/riscv/tcg-target.inc.c        | 1728 +++++++++++++++++++++++++++++
 9 files changed, 2045 insertions(+), 4 deletions(-)
 create mode 100644 linux-user/host/riscv32/hostdep.h
 create mode 100644 linux-user/host/riscv64/hostdep.h
 create mode 100644 tcg/riscv/tcg-target.h
 create mode 100644 tcg/riscv/tcg-target.inc.c

-- 
2.19.1