Re: [Qemu-devel] [qemu-s390x] [PATCH 2/2] s390x/ccw: make sure all ccw devices are properly reset

[Thomas Huth]

On 07.05.2018 17:51, Cornelia Huck wrote:
> Thomas reported that the subchannel for a  3270 device that ended up
> in a broken state (status pending even though not enabled) did not
> get out of that state even after a reboot (which involves a subsytem
> reset). The reason for this is that the 3270 device did not define
> a reset handler.
> 
> Let's fix this by introducing a base reset handler (set up for all
> ccw devices) that resets the subchannel and have virtio-ccw call
> its virtio-specific reset procedure in addition to that.
> 
> Reported-by: Thomas Huth <address@hidden>
> Suggested-by: Christian Borntraeger <address@hidden>
> Signed-off-by: Cornelia Huck <address@hidden>
> ---
>  hw/s390x/ccw-device.c | 8 ++++++++
>  hw/s390x/virtio-ccw.c | 9 ++++++---
>  hw/s390x/virtio-ccw.h | 1 +
>  3 files changed, 15 insertions(+), 3 deletions(-)

Looks good!

Reviewed-by: Thomas Huth <address@hidden>

I also checked that the broken 3270 device is now operational after a
reboot again with your two patches, so:

Tested-by: Thomas Huth <address@hidden>