Re: [Qemu-devel] [PATCH v7 00/13] Add support for the ZynqMP Generic QSPI

[Peter Maydell]

On 3 November 2017 at 00:00, Francisco Iglesias
<address@hidden> wrote:
> Hi,
>
> This patch series is an attempt to add support for the ZynqMP QSPI (consisting
> of the Generic QSPI and the legacy QSPI) to the xlnx-zcu102 board and connect
> Numonyx n25q512a11 flashes to the QSPI. Also some functionality is added to
> m25p80.
>
> The series starts by adding support in m25p80 for continous read out of status
> registers, SST flash READ ID commands, bank address register accesses, bulk
> erase (0x60) and two Numonyx flashes (n25q512a11 and n25q512a13). Thereafter 
> it
> updates the striping behaviour to be bit big endiann in the Xilinx QSPI model
> and adds support for RX discard, zero pumping according transfer register and 
> 4
> byte LQSPI addresses. Finally it adds support for the ZynqMP Generic QSPI and
> adds the ZynqMP QSPI to the xlnx-zcu102 board.
>
> Best regards,
> Francisco Iglesias

Hi; just a note to say that I'm assuming the Xilinx folk are going
to review the xilinx_spips patches in this set...

thanks
-- PMM