[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH v3 0/2] Virtio GPU for S390
From: |
Cornelia Huck |
Subject: |
Re: [Qemu-devel] [PATCH v3 0/2] Virtio GPU for S390 |
Date: |
Mon, 18 Sep 2017 14:29:02 +0200 |
On Fri, 15 Sep 2017 10:40:30 -0400
Farhan Ali <address@hidden> wrote:
> These patches wire up the virtio-gpu device for CCW bus for
> S390.
>
> For the S390 architecture which does not natively support any graphics
> device, virtio gpu in 2D mode could be used to emulate a simple graphics
> card and use VNC as the display.
>
> eg: qemu-system-s390x ... -device virtio-gpu-ccw,devno=fe.0.0101
> -vnc host_ip_addr:5900
>
> Note, to actually see any display content the
> guest kernel needs to support DRM layer, Virtio GPU driver,
> the Virtual Terminal layer etc.
>
> I would appreciate any feedback on these patches, specially the
> first patch.
>
> ChangeLog
> --------
> v1 -> v2
> - remove error_propagate (patch 2)
> - Add byteswap functions (patch 1)
> - Handle endian conversion for virtio_gpu_ctrl_response (patch 1)
>
> v2 -> v3
> - updated patch 1 based on Gerd's feedback
> - rename bswap functions (patch 1)
> - use in-place swapping functions (patch 1)
> - Handle endian conversion for cursor update (patch 1)
>
> Thank you
> Farhan
>
>
> Farhan Ali (2):
> virtio-gpu: Handle endian conversion
> virtio-gpu-ccw: Create a virtio gpu device for the ccw bus
>
> hw/display/virtio-gpu.c | 70
> +++++++++++++++++++++++++++++++++++++++++++------
> hw/s390x/virtio-ccw.c | 49 ++++++++++++++++++++++++++++++++++
> hw/s390x/virtio-ccw.h | 10 +++++++
> 3 files changed, 121 insertions(+), 8 deletions(-)
>
Thanks, applied.