Re: [Qemu-devel] [PATCH v2 06/11] nvdimm acpi: initialize the resource used by NVDIMM ACPI

[Igor Mammedov]

On Thu, 18 Feb 2016 12:03:36 +0800
Xiao Guangrong <address@hidden> wrote:

> On 02/18/2016 01:26 AM, Michael S. Tsirkin wrote:
> > On Wed, Feb 17, 2016 at 10:04:18AM +0800, Xiao Guangrong wrote:  
> >>>>> As for the rest could that commands go via MMIO that we usually
> >>>>> use for control path?  
> >>>>
> >>>> So both input data and output data go through single MMIO, we need to
> >>>> introduce a protocol to pass these data, that is complex?
> >>>>
> >>>> And is any MMIO we can reuse (more complexer？) or we should allocate this
> >>>> MMIO page （the old question - where to allocated?）?  
> >>> Maybe you could reuse/extend memhotplug IO interface,
> >>> or alternatively as Michael suggested add a vendor specific PCI_Config,
> >>> I'd suggest PM device for that (hw/acpi/[piix4.c|ihc9.c])
> >>> which I like even better since you won't need to care about which ports
> >>> to allocate at all.  
> >>
> >> Well, if Michael does not object, i will do it in the next version. :)  
> >
> > Sorry, the thread's so long by now that I'm no longer sure what does "it" 
> > refer to.  
> 
> Never mind i saw you were busy on other loops.
> 
> "It" means the suggestion of Igor that "map each label area right after each
> NVDIMM's data memory"
Michael pointed out that putting label right after each NVDIMM
might burn up to 256GB of address space due to DIMM's alignment for 256 NVDIMMs.
However if address for each label is picked with pc_dimm_get_free_addr()
and label's MemoryRegion alignment is default 2MB then all labels
would be allocated close to each other within a single 1GB range.

That would burn only 1GB for 500 labels which is more than possible 256 NVDIMMs.
Assuming labels are mapped before storage MemoryRegion is mapped, layout with 
1Gb hugepage backend CLI
  -device nvdimm,size=1G -device nvdimm,size=1G -device nvdimm,size=1G
would look like:

0  2M  4M       1G    2G    3G    4G
L1 | L2 | L3 ... | NV1 | NV2 | NV3 |

> so we do not emulate it in QEMU and is good for the performance
> of label these are the points i like. However it also brings 
> complexity/limitation for
> later DSM commands supports since both dsm input & output need to go through 
> single MMIO.
> 
> Your idea?
>