[Qemu-devel] [PATCH v3 06/24] block: Clean up "Could not create temporary overlay" error message

[Markus Armbruster]

bdrv_create() sets an error and returns -errno on failure.  When the
latter is interesting, the error is created with error_setg_errno().

bdrv_append_temp_snapshot() uses the error's message to create a new
one with error_setg_errno().  This adds a strerror() that is either
uninteresting or duplicate.  Use error_setg() instead.

Signed-off-by: Markus Armbruster <address@hidden>
Reviewed-by: Eric Blake <address@hidden>
---
 block.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/block.c b/block.c
index 9971976..4b40cb2 100644
--- a/block.c
+++ b/block.c
@@ -1336,9 +1336,8 @@ int bdrv_append_temp_snapshot(BlockDriverState *bs, int 
flags, Error **errp)
     ret = bdrv_create(&bdrv_qcow2, tmp_filename, opts, &local_err);
     qemu_opts_del(opts);
     if (ret < 0) {
-        error_setg_errno(errp, -ret, "Could not create temporary overlay "
-                         "'%s': %s", tmp_filename,
-                         error_get_pretty(local_err));
+        error_setg(errp, "Could not create temporary overlay '%s': %s",
+                   tmp_filename, error_get_pretty(local_err));
         error_free(local_err);
         goto out;
     }
-- 
2.4.3