[Qemu-devel] [RFC PATCH 2/4] pcie-aer: Fix command pcie_aer_inject_error is invalid

[Chen Fan]

in spec "PCI Express 3.0" section 6.2.6 Figure 6-3 virtual bridge part,
the flowchart showing tell us SERR# enable at Bridge Control register
associate with system error at Secondary Status register can send error
message. but bridge_control from dev->config is NULL, and SERR# was set
in dev->wmask in pcie_aer_init() which was implemented by root port and
swith devices, so we should add wmask (for w/r) bit set for bridge control.
we can user command like:
qemu_system_x86_64:
-device ioh3420,bus=pcie.0,addr=1c.0,multifunction=on,port=1,id=bridge1
-device x3130-upstream,bus=bridge1,id=up.1,addr=00.0
-device xio3130-downstream,bus=up.1,id=down.1,port=1,addr=00.0,chassis=5

(qemu) pcie_aer_inject_error net0 POISON_TLP

after that,
guest can output the error message.

Signed-off-by: Chen Fan <address@hidden>
---
 hw/pci/pcie_aer.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/hw/pci/pcie_aer.c b/hw/pci/pcie_aer.c
index 7ca077a..571dc92 100644
--- a/hw/pci/pcie_aer.c
+++ b/hw/pci/pcie_aer.c
@@ -231,7 +231,8 @@ pcie_aer_msg_alldev(PCIDevice *dev, const PCIEAERMsg *msg)
  */
 static bool pcie_aer_msg_vbridge(PCIDevice *dev, const PCIEAERMsg *msg)
 {
-    uint16_t bridge_control = pci_get_word(dev->config + PCI_BRIDGE_CONTROL);
+    uint16_t bridge_control = pci_get_word(dev->config + PCI_BRIDGE_CONTROL) |
+                              pci_get_word(dev->wmask + PCI_BRIDGE_CONTROL);
 
     if (pcie_aer_msg_is_uncor(msg)) {
         /* Received System Error */
-- 
1.9.3