[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH v3] e1000: clean up phyreg_writeops/set_phy_ctrl
From: |
Michael S. Tsirkin |
Subject: |
Re: [Qemu-devel] [PATCH v3] e1000: clean up phyreg_writeops/set_phy_ctrl |
Date: |
Wed, 2 Jul 2014 12:12:30 +0300 |
On Tue, Jul 01, 2014 at 03:03:48PM -0400, Gabriel L. Somlo wrote:
> Make phyreg_writeops responsible for actually writing their
> respective phy registers. The only current instance of
> phyreg_writeops is set_phy_ctrl(), which we modify to actually
> write the register, while also correctly handling reserved and
> self-clearing bits.
>
> have_autoneg() does not need to check for MII_CR_RESTART_AUTO_NEG,
> since the only time the flag comes into play is during set_phy_ctrl(),
> and never actually gets written to the phy control register. We also
> move it in front of set_phy_ctrl(), to avoid a forward declaration.
>
> Signed-off-by: Gabriel Somlo <address@hidden>
> ---
Reviewed-by: Michael S. Tsirkin <address@hidden>
Applied, thanks!
> Michael, Stefan:
>
> Here's a new version of this patch with slightly better (IMHO) formatting.
> I think the merits are 1. handling bits which are reserved or self
> clearing; and 2. eliminating the surprise of a "write op" that does not
> actually write to its register :)
>
> Regarding the "sibling" patch originally accompanying this one (which
> increased the timer delay for autonegotiation), I'll take a while
> longer to figure out what's really going on, so I'll send out a separate
> patch if/when that happens.
>
> Please apply (or review/critique) this one independently.
>
> Thanks,
> Gabriel
>
> hw/net/e1000.c | 31 +++++++++++++++++--------------
> 1 file changed, 17 insertions(+), 14 deletions(-)
>
> diff --git a/hw/net/e1000.c b/hw/net/e1000.c
> index 0fc29a0..04c0f91 100644
> --- a/hw/net/e1000.c
> +++ b/hw/net/e1000.c
> @@ -186,21 +186,31 @@ e1000_link_up(E1000State *s)
> s->phy_reg[PHY_STATUS] |= MII_SR_LINK_STATUS;
> }
>
> +static bool
> +have_autoneg(E1000State *s)
> +{
> + return (s->compat_flags & E1000_FLAG_AUTONEG) &&
> + (s->phy_reg[PHY_CTRL] & MII_CR_AUTO_NEG_EN);
> +}
> +
> static void
> set_phy_ctrl(E1000State *s, int index, uint16_t val)
> {
> + /* bits 0-5 reserved; MII_CR_[RESTART_AUTO_NEG,RESET] are self clearing
> */
> + s->phy_reg[PHY_CTRL] = val & ~(0x3f |
> + MII_CR_RESET |
> + MII_CR_RESTART_AUTO_NEG);
> +
> /*
> * QEMU 1.3 does not support link auto-negotiation emulation, so if we
> * migrate during auto negotiation, after migration the link will be
> * down.
> */
> - if (!(s->compat_flags & E1000_FLAG_AUTONEG)) {
> - return;
> - }
> - if ((val & MII_CR_AUTO_NEG_EN) && (val & MII_CR_RESTART_AUTO_NEG)) {
> + if (have_autoneg(s) && (val & MII_CR_RESTART_AUTO_NEG)) {
> e1000_link_down(s);
> DBGOUT(PHY, "Start link auto negotiation\n");
> - timer_mod(s->autoneg_timer, qemu_clock_get_ms(QEMU_CLOCK_VIRTUAL) +
> 500);
> + timer_mod(s->autoneg_timer,
> + qemu_clock_get_ms(QEMU_CLOCK_VIRTUAL) + 500);
> }
> }
>
> @@ -446,8 +456,9 @@ set_mdic(E1000State *s, int index, uint32_t val)
> } else {
> if (addr < NPHYWRITEOPS && phyreg_writeops[addr]) {
> phyreg_writeops[addr](s, index, data);
> + } else {
> + s->phy_reg[addr] = data;
> }
> - s->phy_reg[addr] = data;
> }
> }
> s->mac_reg[MDIC] = val | E1000_MDIC_READY;
> @@ -848,14 +859,6 @@ receive_filter(E1000State *s, const uint8_t *buf, int
> size)
> return 0;
> }
>
> -static bool
> -have_autoneg(E1000State *s)
> -{
> - return (s->compat_flags & E1000_FLAG_AUTONEG) &&
> - (s->phy_reg[PHY_CTRL] & MII_CR_AUTO_NEG_EN) &&
> - (s->phy_reg[PHY_CTRL] & MII_CR_RESTART_AUTO_NEG);
> -}
> -
> static void
> e1000_set_link_status(NetClientState *nc)
> {
> --
> 1.9.3