[Qemu-devel] [PATCHv3 1/4] pci_bridge: user-friendly default bus name

[Michael S. Tsirkin]

For a pci bridge device, if we don't override
the name with custom code, the bus will be addressed as
<id>.0, where id is the id specified by the user.

Since PCI Bridge devices have a single bus each, we don't need
the index: address the bus using the parent device name.
This is better since this way users don't care about
our internal bus/device distinctions.

As far as I could see, we only have built-in
bridges at this point which always override the
name. So this change will only affect ioh3420.c.

Signed-off-by: Michael S. Tsirkin <address@hidden>
---
 hw/pci_bridge.c |   10 ++++++++++
 1 files changed, 10 insertions(+), 0 deletions(-)

diff --git a/hw/pci_bridge.c b/hw/pci_bridge.c
index fea3873..eeee8a6 100644
--- a/hw/pci_bridge.c
+++ b/hw/pci_bridge.c
@@ -314,6 +314,16 @@ int pci_bridge_initfn(PCIDevice *dev)
     pci_set_word(dev->config + PCI_SEC_STATUS,
                  PCI_STATUS_66MHZ | PCI_STATUS_FAST_BACK);
 
+    /*
+     * If we don't specify the name, the bus will be addressed as <id>.0, where
+     * id is the device id.
+     * Since PCI Bridge devices have a single bus each, we don't need the 
index:
+     * let users address the bus using the device name.
+     */
+    if (!br->bus_name && dev->qdev.id && *dev->qdev.id) {
+           br->bus_name = dev->qdev.id;
+    }
+
     qbus_create_inplace(&sec_bus->qbus, &pci_bus_info, &dev->qdev,
                         br->bus_name);
     sec_bus->parent_dev = dev;
-- 
1.7.9.111.gf3fb0