[Qemu-devel] [PATCH] mst_fpga: correct irq level settings

[Dmitry Eremin-Solenikov]

Final corrections for IRQ levels that are set by mst_fpga:

* Don't retranslate IRQ if previously IRQ was masked.
* After setting or clearing IRQs through register, apply mask
  before setting parent IRQ level.

Signed-off-by: Dmitry Eremin-Solenikov <address@hidden>
---
 hw/mst_fpga.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/hw/mst_fpga.c b/hw/mst_fpga.c
index afed2ac..407bac9 100644
--- a/hw/mst_fpga.c
+++ b/hw/mst_fpga.c
@@ -50,7 +50,7 @@ static void
 mst_fpga_set_irq(void *opaque, int irq, int level)
 {
        mst_irq_state *s = (mst_irq_state *)opaque;
-       uint32_t oldint = s->intsetclr;
+       uint32_t oldint = s->intsetclr & s->intmskena;
 
        if (level)
                s->prev_level |= 1u << irq;
@@ -139,7 +139,7 @@ mst_fpga_writeb(void *opaque, target_phys_addr_t addr, 
uint32_t value)
                break;
        case MST_INTSETCLR:     /* clear or set interrupt */
                s->intsetclr = (value & 0xFEEFF);
-               qemu_set_irq(s->parent, s->intsetclr);
+               qemu_set_irq(s->parent, s->intsetclr & s->intmskena);
                break;
        case MST_PCMCIA0:
                s->pcmcia0 = value;
-- 
1.7.2.3