Hi all,
the usb-hid spec states that the SET_IDLE request has a 16bit value,
where the upper byte specifies the idle rate (currently unimplemented,
we handle only the 0 case, meaning infinite duration) and the lower
byte specifies the report id (0 means all reports).
In our code we do idle = value, while it should be idle = "upper byte",
especially if the guest issues a GET_IDLE, we should return only the
idle rate while we are returning only the report id.
In practice it doesn't make much difference because I have only seen
SET_VALUE with both bytes set to 0 so far, but still it is wrong.
Signed-off-by: Stefano Stabellini <address@hidden>