Re: [Qemu-block] [PATCH v4 10/10] block/pflash_cfi02: Use the chip erase time specified in the CFI table

[Philippe Mathieu-Daudé]

On 4/26/19 6:26 PM, Stephen Checkoway wrote:
> When erasing the chip, use the typical time specified in the CFI table
> rather than arbitrarily selecting 5 seconds.
> 
> Since the currently unconfigurable value set in the table is 12, this
> means a chip erase takes 4096 ms so this isn't a big change in behavior.
> 
> Signed-off-by: Stephen Checkoway <address@hidden>
> ---
>  hw/block/pflash_cfi02.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/hw/block/pflash_cfi02.c b/hw/block/pflash_cfi02.c
> index d9087cafff..76c8af4365 100644
> --- a/hw/block/pflash_cfi02.c
> +++ b/hw/block/pflash_cfi02.c
> @@ -633,9 +633,9 @@ static void pflash_write(void *opaque, hwaddr offset, 
> uint64_t value,
>                  pflash_update(pfl, 0, pfl->total_len);
>              }
>              set_dq7(pfl, 0x00);
> -            /* Let's wait 5 seconds before chip erase is done */
> +            /* Wait the time specified at CFI address 0x22. */
>              timer_mod(&pfl->timer, qemu_clock_get_ns(QEMU_CLOCK_VIRTUAL) +
> -                      (NANOSECONDS_PER_SECOND * 5));
> +                      (1ULL << pfl->cfi_table[0x22]) * SCALE_MS);
>              break;
>          case 0x30:
>              /* Sector erase */
> 

Reviewed-by: Philippe Mathieu-Daudé <address@hidden>
Tested-by: Philippe Mathieu-Daudé <address@hidden>