[Qemu-arm] [PATCH RESEND v3 3/3] hw/pci-host/gpex: Implement PCI INTx routing

[Eric Auger]

From: Pranavkumar Sawargaonkar <address@hidden>

Now we are able to retrieve the gsi from the INTx pin, let's
enable intx_to_irq routing. From that point on, irqfd becomes
usable along with INTx when assigning a PCIe device.

Signed-off-by: Pranavkumar Sawargaonkar <address@hidden>
Signed-off-by: Tushar Jagad <address@hidden>
Signed-off-by: Eric Auger <address@hidden>
---
 hw/pci-host/gpex.c | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/hw/pci-host/gpex.c b/hw/pci-host/gpex.c
index 0d42ac2..94cc3c1 100644
--- a/hw/pci-host/gpex.c
+++ b/hw/pci-host/gpex.c
@@ -53,6 +53,17 @@ int gpex_set_irq_num(GPEXHost *s, int index, uint32_t gsi)
     return 0;
 }
 
+static PCIINTxRoute gpex_route_intx_pin_to_irq(void *opaque, int pin)
+{
+    PCIINTxRoute route;
+    GPEXHost *s = opaque;
+
+    route.mode = PCI_INTX_ENABLED;
+    route.irq = (int)s->irq_num[pin];
+
+    return route;
+}
+
 static void gpex_host_realize(DeviceState *dev, Error **errp)
 {
     PCIHostState *pci = PCI_HOST_BRIDGE(dev);
@@ -77,6 +88,7 @@ static void gpex_host_realize(DeviceState *dev, Error **errp)
                                 &s->io_ioport, 0, 4, TYPE_PCIE_BUS);
 
     qdev_set_parent_bus(DEVICE(&s->gpex_root), BUS(pci->bus));
+    pci_bus_set_route_irq_fn(pci->bus, gpex_route_intx_pin_to_irq);
     qdev_init_nofail(DEVICE(&s->gpex_root));
 }
 
-- 
2.5.5