[Qemu-arm] [PATCH RESEND v3 2/3] hw/arm/virt: Set INTx/gsi mapping

[Eric Auger]

From: Pranavkumar Sawargaonkar <address@hidden>

Let's provide the GPEX host bridge with the INTx/gsi mapping. This is
needed for INTx/gsi routing.

Signed-off-by: Pranavkumar Sawargaonkar <address@hidden>
Signed-off-by: Tushar Jagad <address@hidden>
Signed-off-by: Eric Auger <address@hidden>
---
 hw/arm/virt.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/hw/arm/virt.c b/hw/arm/virt.c
index 010f724..f86c229 100644
--- a/hw/arm/virt.c
+++ b/hw/arm/virt.c
@@ -1012,6 +1012,7 @@ static void create_pcie(const VirtMachineState *vms, 
qemu_irq *pic)
     char *nodename;
     int i;
     PCIHostState *pci;
+    GPEXHost *s;
 
     dev = qdev_create(NULL, TYPE_GPEX_HOST);
     qdev_init_nofail(dev);
@@ -1047,8 +1048,11 @@ static void create_pcie(const VirtMachineState *vms, 
qemu_irq *pic)
     /* Map IO port space */
     sysbus_mmio_map(SYS_BUS_DEVICE(dev), 2, base_pio);
 
+    s = GPEX_HOST(dev);
+
     for (i = 0; i < GPEX_NUM_IRQS; i++) {
         sysbus_connect_irq(SYS_BUS_DEVICE(dev), i, pic[irq + i]);
+        gpex_set_irq_num(s, i, irq + i);
     }
 
     pci = PCI_HOST_BRIDGE(dev);
-- 
2.5.5