[Qemu-arm] [PATCH 2/4] aspeed: remove useless comment on controller segment size

[Cédric Le Goater]

The flash devices used for the FMC controller (BMC firmware) are well
defined for each Aspeed machine and are all smaller than the default
mapping window size, at least for CE0 which is the chip the SoC boots
from.

Signed-off-by: Cédric Le Goater <address@hidden>
---
 hw/arm/aspeed.c | 8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git a/hw/arm/aspeed.c b/hw/arm/aspeed.c
index ac9cbd66b72a..283c03881493 100644
--- a/hw/arm/aspeed.c
+++ b/hw/arm/aspeed.c
@@ -148,10 +148,6 @@ static void aspeed_board_init_flashes(AspeedSMCState *s, 
const char *flashtype,
         DriveInfo *dinfo = drive_get_next(IF_MTD);
         qemu_irq cs_line;
 
-        /*
-         * FIXME: check that we are not using a flash module exceeding
-         * the controller segment size
-         */
         fl->flash = ssi_create_slave_no_init(s->spi, flashtype);
         if (dinfo) {
             qdev_prop_set_drive(fl->flash, "drive", blk_by_legacy_dinfo(dinfo),
@@ -210,7 +206,9 @@ static void aspeed_board_init(MachineState *machine,
 
         /*
          * create a ROM region using the default mapping window size of
-         * the flash module.
+         * the flash module. The window size is 64MB for the AST2400
+         * SoC and 128MB for the AST2500 SoC, which is twice as big as
+         * needed by the flash modules of the Aspeed machines.
          */
         memory_region_init_rom(boot_rom, OBJECT(bmc), "aspeed.boot_rom",
                                fl->size, &error_abort);
-- 
2.7.4