[Qemu-arm] [PATCH v5 2/9] m25p80: do not put iovec on the stack

[Cédric Le Goater]

From: Paolo Bonzini <address@hidden>

When doing a read-modify-write cycle, QEMU uses the iovec after returning
from blk_aio_pwritev.  m25p80 puts the iovec on the stack of blk_aio_pwritev's
caller, which causes trouble in this case.  This has been a problem
since commit 243e6f6 ("m25p80: Switch to byte-based block access",
2016-05-12) started doing writes at a smaller granularity than 512 bytes.
In principle however it could have broken before when using -drive
if=mtd,cache=none on a disk with 4K native sectors.

Signed-off-by: Paolo Bonzini <address@hidden>
Reviewed-by: Cédric Le Goater <address@hidden>
Reviewed-by: Eric Blake <address@hidden>
Signed-off-by: Cédric Le Goater <address@hidden>
---
 hw/block/m25p80.c | 23 ++++++++++++++---------
 1 file changed, 14 insertions(+), 9 deletions(-)

diff --git a/hw/block/m25p80.c b/hw/block/m25p80.c
index 3cdcfce07ba9..8e4c11573521 100644
--- a/hw/block/m25p80.c
+++ b/hw/block/m25p80.c
@@ -447,6 +447,11 @@ static inline Manufacturer get_man(Flash *s)
 
 static void blk_sync_complete(void *opaque, int ret)
 {
+    QEMUIOVector *iov = opaque;
+
+    qemu_iovec_destroy(iov);
+    g_free(iov);
+
     /* do nothing. Masters do not directly interact with the backing store,
      * only the working copy so no mutexing required.
      */
@@ -454,31 +459,31 @@ static void blk_sync_complete(void *opaque, int ret)
 
 static void flash_sync_page(Flash *s, int page)
 {
-    QEMUIOVector iov;
+    QEMUIOVector *iov = g_new(QEMUIOVector, 1);
 
     if (!s->blk || blk_is_read_only(s->blk)) {
         return;
     }
 
-    qemu_iovec_init(&iov, 1);
-    qemu_iovec_add(&iov, s->storage + page * s->pi->page_size,
+    qemu_iovec_init(iov, 1);
+    qemu_iovec_add(iov, s->storage + page * s->pi->page_size,
                    s->pi->page_size);
-    blk_aio_pwritev(s->blk, page * s->pi->page_size, &iov, 0,
-                    blk_sync_complete, NULL);
+    blk_aio_pwritev(s->blk, page * s->pi->page_size, iov, 0,
+                    blk_sync_complete, iov);
 }
 
 static inline void flash_sync_area(Flash *s, int64_t off, int64_t len)
 {
-    QEMUIOVector iov;
+    QEMUIOVector *iov = g_new(QEMUIOVector, 1);
 
     if (!s->blk || blk_is_read_only(s->blk)) {
         return;
     }
 
     assert(!(len % BDRV_SECTOR_SIZE));
-    qemu_iovec_init(&iov, 1);
-    qemu_iovec_add(&iov, s->storage + off, len);
-    blk_aio_pwritev(s->blk, off, &iov, 0, blk_sync_complete, NULL);
+    qemu_iovec_init(iov, 1);
+    qemu_iovec_add(iov, s->storage + off, len);
+    blk_aio_pwritev(s->blk, off, iov, 0, blk_sync_complete, iov);
 }
 
 static void flash_erase(Flash *s, int offset, FlashCMD cmd)
-- 
2.1.4