[Qemu-arm] [PATCH v2 4/5] arm: boot: Add secure_board_setup flag

[Peter Crosthwaite]

Add a flag that when set, will cause the primary CPU to start in secure
mode, even if the overall boot in non-secure. This is useful for when
there is a board-setup blob that needs to run from secure mode, but
device and secondary CPU init should still be done as-normal for a non-
secure boot.

Signed-off-by: Peter Crosthwaite <address@hidden>
---

 hw/arm/boot.c        | 3 ++-
 include/hw/arm/arm.h | 6 ++++++
 2 files changed, 8 insertions(+), 1 deletion(-)

diff --git a/hw/arm/boot.c b/hw/arm/boot.c
index b0879a5..6680d45 100644
--- a/hw/arm/boot.c
+++ b/hw/arm/boot.c
@@ -495,7 +495,8 @@ static void do_cpu_reset(void *opaque)
                 }
 
                 /* Set to non-secure if not a secure boot */
-                if (!info->secure_boot) {
+                if (!info->secure_boot &&
+                    (cs != first_cpu || !info->secure_board_setup)) {
                     /* Linux expects non-secure state */
                     env->cp15.scr_el3 |= SCR_NS;
                 }
diff --git a/include/hw/arm/arm.h b/include/hw/arm/arm.h
index 9217b70..60dc919 100644
--- a/include/hw/arm/arm.h
+++ b/include/hw/arm/arm.h
@@ -97,6 +97,12 @@ struct arm_boot_info {
     hwaddr board_setup_addr;
     void (*write_board_setup)(ARMCPU *cpu,
                               const struct arm_boot_info *info);
+
+    /* If set, the board specific loader/setup blob will be run from secure
+     * mode, regardless of secure_boot. The blob becomes responsible for
+     * changing to non-secure state if implementing a non-secure boot
+     */
+    bool secure_board_setup;
 };
 
 /**
-- 
1.9.1