Hi there
I did that, and the results i get is like on/off only, it is strange.
I also try this experiment on the Futaba Skysport 4, some how it gives 3
state, but the neutral react very slow, and when i put it in paparazzi, it
tend to shut of the rc link.
Thanks anyway
Chen
> From: address@hidden
> To: address@hidden
> Subject: Re: [Paparazzi-devel] 3 state switch on any R/C controller
> Date: Sat, 30 May 2009 21:08:07 +0400
>
> Hello
> try to add two resistor divider between switch inputs. this would give
> central position.
>
> 30.05.09, 17:04, "? flying pig" <address@hidden>:
>
> > Hi there
> >
> > I have recently got one of the remote controll from someone, it is 4
> > channel 40Mhz, the brand is REELY (from Conrad in Germany i believe).
> > I was thinking using for paparazzi.
> >
> > I have tap in to the R/C receiver, which was ok (just read the chip
> > number without any measurement), however, I have some didfficulty in
> > making 3 state switch.
> >
> >
> > I cut the yaw channel (4th channel), and rewire to 3 state s
witch (on/off/on), however, when i use it, it seen like only have on/off
function.
> >
> >
> > Does anyone has done the similar thing about cutting one channel from
> > the controller to make it into the 3 state switch? can anyone advice?
> >
> >
> >
> > Regards
> >
> > &nbs
p; Chen
> > 5 GB ???? ????????????????? ? ???? Windows Live Hotmail
> --
> Есть ли письма? Знает мобильная Яндекс.Почта
> http://mobile.yandex.ru/online
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
5 GB ???? ????????o??]???? ? ??? Windows Live Hotmail