[Octave-bug-tracker] [bug #54796] Consecutive plots drift out of the figure area

[Pantxo Diribarne]

Update of bug #54796 (project octave):

                Category:                Plotting => Plotting with OpenGL   
                  Status:            Works For Me => Fixed                  
             Open/Closed:                    Open => Closed                 

    _______________________________________________________

Follow-up Comment #3:

@Tunc: After looking again at Octave 4.2.2 I can confirm that I sometimes
observe a similar effect, one of the output png files is sometimes smaller
than expected (1167-by-875 instead of 1200-by-900 pixels) and the xlabel
partly goes outside the canvas. To trigger the bug I have to first switch to
fltk toolkit, draw a figure, switch back to Qt tookit and then run the
original snippet.

Anyway, even with the above procedure I still cannot reproduce the bug with
Octave 4.4.1 and dev. This is somewhat the same as what Rik observed in bug
#51829. As he said this bug seams to be gone in the current Octave version
(4.4.1), while it was present in previous versions including 4.2,  and I'll
close this report as fixed.

    _______________________________________________________

Reply to this item at:

  <https://savannah.gnu.org/bugs/?54796>

_______________________________________________
  Message sent via Savannah
  https://savannah.gnu.org/