[Octave-bug-tracker] [bug #50479] build fails on osmesa print

[Michael Godfrey]

Follow-up Comment #25, bug #50479 (project octave):

I just run ./configure
and I did a clean rebuild recently.
It appeared that this was what fixed it for me. But,...

The unexplained behavior is that I have osmesa and the
build uses it, and that works, but the build of the
/doc/interpreter stuff uses gnuplot!!!
I think that there was a change in the build script
to use gnuplot even though osmesa and everything that
fltk and qt needs are available.

However, this does not explain Dmitri's problem.

    _______________________________________________________

Reply to this item at:

  <http://savannah.gnu.org/bugs/?50479>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.gnu.org/