[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: lynx-dev lynx2.8.5dev.4

From: Thomas Dickey
Subject: Re: lynx-dev lynx2.8.5dev.4
Date: Thu, 8 Nov 2001 19:14:20 -0500
User-agent: Mutt/1.2.5i

On Fri, Nov 09, 2001 at 12:30:11AM +0100, Michel SUCH wrote:
> On Thu, 8 Nov 2001 16:09:39 -0500, Thomas Dickey wrote:
> >* correct the following names in LYrcFile.c which were added to allow
> >  ENABLE_LYNXRC lines in lynx.cfg to enable them to be saved in ~/.lynxrc
> >    old           new          where-used
> >    -------------------------------------
> >    DTD_recovery  tagsoup      (command-line option and lynx.cfg)
> >    show_rate     show_kb_rate (lynx.cfg)
> >    user_agent    useragent    (command-line option)
> This still does not seem to work, at least for DTD_recovery  tagsoup.
> Even if setting the following in lynx.cfg:
> the (!) remains before the option in the
> option menu. I can probably save it but it is not reapplied when reloading

I'll double-check.  When you first reported this, I recalled noting that
there was some problem, but when I tested this on the weekend, I was able
to save/restore the value, so I didn't look further.  Just a quick check
shows the '!', but that I can save/restore the value:

RCS file: RCS/.lynxrc,v
retrieving revision 1.3
diff -r1.3 .lynxrc
< sub_bookmarks=standard
> sub_bookmarks=ADVANCED
> # Normally disabled.  See ENABLE_LYNXRC in lynx.cfg
> tagsoup=on

Thomas E. Dickey <address@hidden>

; To UNSUBSCRIBE: Send "unsubscribe lynx-dev" to address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]