Re: [Ltib] I2C don't work

[Stuart Hughes]

Hi Roberto,

This is not really an LTIB question.  You'll need to ask for support
from your hardware vendor/supplier.

Regards, Stuart

On Mon, 2009-02-23 at 10:27 +0000, Roberto Spelta wrote:
> Hi, i have a phyCORE®-LPC3250, carrier board 1305.1, lcd module 1307.0
> and CPU module 1304.1.
> with the documentation:
> LPC32xx Linux Board Support Package (BSP) Quickstart Guide for the
> Phytec LPC3250 Board, V1.00  (Jan 12, 2009)
> [http://www.standardics.nxp.com/support/software/lpc32xx.bsp.linux/]
> i have a problem:
> when the boot linux try to load the ohci_hdc (USB OTG I2C channel is
> enabled) kernel boot freeze.
> Without I2C linux kernel works with the message to the boot:
> ohci_hcd: I2C slave device not found.
> USB don't work.
> 
> Why the I2C is not supported? I must use the usb, what do i do?
> 
> Thanks!
> 
> 
> 
> ______________________________________________________________________
> Passa a Yahoo! Mail. 
> La webmail che ti offre GRATIS spazio illimitato, antispam e messenger
> integrato.            
> _______________________________________________
> LTIB home page: http://bitshrine.org
> 
> Ltib mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/ltib