[lmi] [PATCH 2/2] Make InputSequenceEntry's "..." button smaller.

[Vaclav Slavik]

Fixes two issues with it:

1) Match height of wxTextCtrl. It was a few pixels taller before,
because wxButton's default height was apparently too big. This made the
whole control too tall. Fixed by setting the height to nonsense value of
1; sizers will take care of sizing it appropriately.

2) The button was a bit too big, because default wxButton content
padding is generous. Explicitly size it to a bit over the size of the
"..." label, to make it smaller and leave more space for the actual
content of the control.
---
 input_sequence_entry.cpp |    5 +++++
 1 files changed, 5 insertions(+), 0 deletions(-)

diff --git a/input_sequence_entry.cpp b/input_sequence_entry.cpp
index b42003f..9accfd8 100644
--- a/input_sequence_entry.cpp
+++ b/input_sequence_entry.cpp
@@ -1063,6 +1063,11 @@ InputSequenceButton::InputSequenceButton(wxWindow* 
parent, wxWindowID id)
             );
 
     SetToolTip("Open sequence editor");
+
+    // Set vertical size to 1px - it's ridiculously small, but the sizers will 
make it as
+    // tall as the text control. Use text extent of "..." for width, because 
standard
+    // buttons use more padding.
+    SetMinSize(wxSize(8 + GetTextExtent(GetLabel()).x, 1));
 }
 
 void InputSequenceButton::UponKillFocus(wxFocusEvent& event)
-- 
1.7.5.4