Re: Re:Re: How to thing a staff's lines

[Trevor Daniels]

James Lowe wrote Monday, April 04, 2011 11:30 AM

> > Thanks. But I can't find the default value in the IR. Where's it?

> > Yes I cannot find it either
> >
> > My route is this:
> >
> > http://lilypond.org/doc/v2.13/Documentation/internals/staff_002dsymbol_002dinterface
> >
> > Takes you to the starting point
> >
> > and this links to
> >
> > http://lilypond.org/doc/v2.13/Documentation/internals/staffsymbol
> >
> > Which lists ' ledger-line-thickness' but not 'thickness'.
> >
> > So it doesn't appear to be listed.

You haven't got to the end of the trail yet.  The properties listed
under a grob are just those that are set specifically for grobs of
that type.  The full list of properties which the grob might use
are listed in the interfaces supported by that object.  These are
listed at the bottom.  Try looking in staff-symbol-interface.

This process is explained in the Learning Manual.  See
http://lilypond.org/doc/v2.13/Documentation/learning/the-internals-reference-manual

Trevor