[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: String number indication, cross-staff kneed beam
From: |
Keith OHara |
Subject: |
Re: String number indication, cross-staff kneed beam |
Date: |
Sun, 27 Feb 2011 19:17:54 +0000 (UTC) |
User-agent: |
Loom/3.14 (http://gmane.org/) |
Nick Payne <nick.payne <at> internode.on.net> writes:
>
> See below. The output is fine until I add the '\3' string number
> indication to the last note on the lower stave, at which point the
> output gets garbaged. The problem doesn't happen if the string number
> orientation is set to down rather than up, nor does it happen with a
> kneed beam on a single staff with the string number orientation up.
>
> \stemUp
> \change Staff = "high"
> \stemDown bes32[
> \change Staff = "low"
> \stemUp <a-1> <c-4\3>16]
> }
This bug is known (issue 1300) but I don't know of a good general workaround,
other than setting the stem directions and beam positions by hand
(section 4.5.2, Fixing overlapping notation).