Re: Chord changes under voltas?

[Mats Bengtsson]

You can't have searched very thoroughly, this topic has
been discussed several times on the mailing lists.
There are two main solutions for you:
- Update to version 2.11.x where the voltas appear
 above the chord names by default. Although 2.11 is an
 "unstable development" version, I would still classify it
 as at least as good as 2.10 if you want to do serious
 typesetting.
- Take a look at the "volta-chord-names.ly" example
 in the Tips and Tricks document in the documentation
 for version 2.10.

  /Mats

eric raeburn wrote:

> There was a short thread on this topic in Feb-March 2003 ("Chords 
> under voltas?"), apparently unresolved, and I could find no more 
> recent discussion of this topic.
>
> I am using Lilypond to produce jazz leadsheets.  Lilypond prints chord 
> symbols above volta lines.  This is most unorthodox and 
> disconcerting--the symbols should be above the staff but below the 
> volta.  I am using 2.10.29.
>
> Is there a workaround, or should this be reported as a bug?
>
> Thanks,
> -Eric
>
>
> _______________________________________________
> lilypond-user mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/lilypond-user



--
=============================================
        Mats Bengtsson
        Signal Processing
        Signals, Sensors and Systems
        Royal Institute of Technology
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
       Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================