[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: building, where to get libfontconfig-dev and libfreetype6-dev
From: |
Bob |
Subject: |
Re: building, where to get libfontconfig-dev and libfreetype6-dev |
Date: |
Fri, 28 Dec 2007 13:33:34 +0000 (UTC) |
User-agent: |
Loom/3.14 (http://gmane.org/) |
Graham Percival <gpermus <at> gmail.com> writes:
>
> On Fri, 28 Dec 2007 04:12:56 +0000 (UTC)
> Bob <me13013 <at> gmail.com> wrote:
>
> > Graham Percival <gpermus <at> gmail.com> writes:
> >
> > > > Am trying to build lilypond 2.11.36 on mac osx
> > > > 10.4.11 (on an intel mac). I only want to use midi2ly (and
> > > > intended to feed that output into an pre-built lilypond binary)
> > > > but it appears I have to build the whole kit
> > > > and caboodle to use midi2ly.
> > >
> > > False. Read the documentation, particularly "macosx command-line
> > > setup".
> > >
> > > - Graham
> >
> > If you are right, that would save me a lot of time.
>
> I'm right.
>
> > However, I
> > am unable to locate "macosx command-line setup" in the documentation.
> > I have looked in lilypond.pdf (for version 2.8.8; this doc just now
> > downloaded), and in the README.txt and in the INSTALL.txt. Where
> > is it?
>
> Look at the docs for 2.11.36 if that's what you're using.
> Application Usage, 2.1.1 I believe.
>
> In the docs for 2.10, I think it's something like section 15.3.
> Just look for OS X in the table of contents.
>
> - Graham
Thanks. Found it now. In the 2.8.8 docs it was section 12.2.
(chuckle) wish I'd found that before I
embarked on the build process. All the dependency builds
and updates took nearly four hours. I
actually got to the point where ./profile was satisfied, but
"make all" fails (don't worry, I will just use the
pre-built installation, which is what I'd rather
have done in the first place).
Thanks,
Bob H