Re: [libredwg] Segmentation Fault

[Davinder Kumar]

On 24 June 2011 00:35, R. van Twisk <address@hidden> wrote:
>
> On Jun 23, 2011, at 1:50 PM, Davinder Kumar wrote:
>
>> On 23 June 2011 17:03, R. van Twisk <address@hidden> wrote:
>>>
>>> On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote:
>>>
>>>> Hello everyone,
>>>> I am using libredwg.Whenever i used convert command like
>>>> ./testSVG input.dwg > output.svg
>>>> it gives following error
>>>> "Segmentation fault"
>>>
>>>
>>> David, what version of dwg is that?
>> If you are talking about version of libredwg, then i don't know the
>> version of  libredwg.I have just installed it through git-clone with
>> following command
>
> No, the version of the DWG, 2010 versions never worked for me.
You are using which version?
>
> Ries
>
>> git clone git://git.sv.gnu.org/libredwg.git
>>> I noticed that DWG version 2010 (I believe)
>>> will always segfault.
>> Any solution to this.Tell me where i can get the newest version of libredwg.
>>>
>>> THis was tested with a draftsight export.
>>> OK.
>>> Ries
>>>
>>>>
>>>>
>>>> --
>>>> http://davinder.in
>>>> Dont hurt the web, use open standards
>>>>
>>>
>>>
>>>
>>
>>
>>
>> --
>> http://davinder.in
>> Dont hurt the web, use open standards
>>
>
>
>



-- 
http://davinder.in
Dont hurt the web, use open standards