Re: [libredwg] [bug #28858] Segfaults on DWG file

[Wookey]

+++ Felipe Sanches [2010-02-15 15:20 -0200]:
> 
> 
> On Mon, Feb 15, 2010 at 3:28 PM, Wookey <address@hidden> wrote:
> 
>     +++ Felipe Sanches [2010-02-15 14:00 -0200]:
> 
>     > Can you provide us a screenshot of the correct output when the dwg file
>     is
>     > opened in AutoCAD ?
> 
>     Better than a screenshot: http://wookware.org/files/23Nightingale.pdf
>     That was produced by autoCAD (or some converter)

OK. I now have the DXF file exported from autoCAD of the same drawing.
That has a load of info about viewports and layers lost in the PDF.

Not sure if it is still needed, but it's probably helpful. Now
available at: http://wookware.org/files/23Nightingale.dxf

I've not managed to reproduce Felipe's work here because I got into a
mess with git. I applied his original patch sent over email directly
and now I can't pull because a couple of files are changed and I don't
have the git-foo for 'ignore local changes, just go get upstream
again' (short of deleting it and cloning again - which may be the
right answer?)

Wookey
-- 
Principal hats:  iEndian - Balloonboard - Toby Churchill - Emdebian
http://wookware.org/