[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Kde-i18n-pl-adm] New software uploaded by Joe on Nov 20 00:40:00 MSK 20
[Kde-i18n-pl-adm] New software uploaded by Joe on Nov 20 00:40:00 MSK 2006
Sun, 19 Nov 2006 22:57:39 +0100
Joe has uploaded some new software for you!
Click here to view available updated software from Joe:
I've had pretty good luck with both 8mm drives from Exabyte and 4mm
# /etc/printcap for host orchid - no multiple copies for local
effect, things like ``delete line 23'', ``add these two lines after
into the lang/tcl subdirectory of your ports tree to build and install
10.4.2.2.5. Device addressing
listing is incompatible with the input syntax used by the
transfers per second (20 Mbytes/sec on a 8 bit bus), Fast-40 is 40
39:roc *) 0xf07c0c00) (../../i386/isa/pcvt/pcvt_drv.c line 403)
results at LISA V in Oct. 1991.
This is a forum for technical discussions related to FreeBSD.
a FreeBSD 2.x system, usually the right answer is to use the BSD
www.adaptec) and answered NO to the question whether the disk
with more enthusiasm than knowledge of how to deal with
using 10.9.9 then the default routes would be:
should not be able to open the communications port until CD (carrier
being easily exposed, passwords have traditionally been scrambled in
4rd ed. Prentice Hall, 1995.
16 Apr 1995.
&& exit 0 \
bad144. First of all, the slice cannot have more than 126 bad
Refer to a hardware data book for precise programming details for the
o Have FreeBSD's serial line driver automatically convert LF to
bus. For wide buses this increases to the number of data lines.
you only have floppy disks, consider using fdwrite to make a copy.
20.1. Debugging a kernel crash dump with kgdb
to get starting totals, then adds information from the regular
immediately to 0x7c0:0. (This is nothing magic, just an adjustment
their routes automatically configured by a daemon called routed. If
need to download those sources as well. Re-build and
custom configuration file, copy the file GENERICAH (or GENERICBT, if
savecore -N /kernel.panicked /var/crash
host default gateway interface
files. Isn't that great?!? :)
This variable specifies executables this port requires to fetch. Like
that, if given the choice between having us answer lots of
crw-rw---- 1 uucp dialer 28, 193 Feb 15 14:38 /dev/cual01
The ``network-related'' pseudo-devices are in that section, while the
o Walnut Creek CDROM has donated almost more than we can say (see the
the ending iteration number; and the rest is as before. Note that
have in common that they attempt to work around the limitations posed
be terminated at the last drive on the chain. For this purpose ESDI
Bit 1 Interrupt ID Bit #0
The Regents of the University of California. All rights reserved.
tapes. QIC may be the correct choice. QIC is the most common tape
PREFIX=/u/people/guests/wurzburger/local make install
the DMA does not place addresses and I/O control signals on the
notice, this list of conditions and the following disclaimer in the
your printers, usage patterns, and maintenance fees and have come up
Native capacity is 150/250MB. Both 150MB (DC6150) and 250MB (DC6250)
routing protocols (RIP/OSPF/BGP/EGP) to tell other routers about your
o FTP servers
software. The reason is that the most important table set by
Otherwise, funny things may happen.
Data transfer rate is 183kB/s.
The ``deltas'' you feed CTM can be had two ways, FTP or e-mail. If
National (NS16550AFN) 0
# Convert and print. Return value from dvilj2p does not seem to be
184.108.40.206.5. Automated Conversion: An Alternative To Conversion Filters
The program /usr/libexec/lpr/lpf that comes with FreeBSD binary
hour spent now, may save you from further distress later.
IP address of your providers gateway, and 0xffffffff is the netmask
5.3.2. General Options
Packard DeskJet 500 printers. For other printers, substitute the
gzip -c -best /sbin/fsck > /mnt/sbin/fsck
Bit 1 Enable Transmitter Holding Register
aware of some quirks related to PC BIOSes. The PC BIOS in its first
5.3.2. General Options
# place boot blocks on the floppy
o The industry standard X Window System (X11R6) provides a graphical
[janegrumble 574] rlogin grunt
device cx0 at isa? port 0x240 net irq 15 drq 7 vector cxintr
configuration file. The "archive set" also contains nightly
messages sent to a list within the scope of the guidelines.
configuration. To add support for a parallel port, see that section
The standard scenario is that you FTP down the tarball, extract it
3. Select the Options item and set any special preferences you may
stack of printouts they stand out from the real documents that
file. It uses these values to determine how much text can fit on a
line, lprm removes the currently active job on the default
This is particular interesting since you can boot from a write-
Make the installation dependent to the variable NOPORTDOCS so that
Contributions to the system generally fall into one or more of the
o Danpex EN-9400P3
#if (defined(BSD) && (BSD >= 199103))
32768 vector ixintr
placed in parenthesis in written documentation, so chmod(1) refers to
220.127.116.11. The pkg directory
10.3.3.2.1. Digi International (DigiBoard) PC/8
Valid actions are:
earlier port screwed up and used it in the wrong place does not mean
to get you into trouble.
(This is a limitation of the PC
an easy way of tracking one central code base, not to keep potential
Reported by: mark thompson mark.a.thompsonpobox
use the Linux /proc filesystem (which is different from the optional
|[Prev in Thread]
||[Next in Thread]|
- [Kde-i18n-pl-adm] New software uploaded by Joe on Nov 20 00:40:00 MSK 2006,
Catriona Allison <=