[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Jhandles axes ranges
From: |
Michael Goffioul |
Subject: |
Re: Jhandles axes ranges |
Date: |
Mon, 16 Jun 2008 12:08:45 +0200 |
OK, maybe I misunderstood your problem. I understand that you
have 3 surfaces, and you want each of them in a single color, but
different for each surface, right?
This can be achieved with the "facecolor" property of the surface
object. For instance:
surf(peaks, 'facecolor', 'r')
will produce the surface in red. Is this what you want?
Michael.
On Mon, Jun 16, 2008 at 12:01 PM, Janmaat, John <address@hidden> wrote:
> Checked the help. caxis talks about bounding the color map. As I have
> intersecting surfaces, I found that the visibility is best when there is only
> one color per surface, rather than the standard color map.
>
> John.
>
>
> ====================================================
> Johannus (John) Janmaat
> Assistant Professor of Economics
> Barber School of Arts and Sciences
> University of British Columbia - Okanagan
> address@hidden
>
>
>
> -----Original Message-----
> From: Michael Goffioul [mailto:address@hidden
> Sent: Mon 2008-06-16 1:21 AM
> To: Janmaat, John
> Cc: Ben Abbott; address@hidden
> Subject: Re: Jhandles axes ranges
>
> Then what you need to do is to adjust clim to match zlim.
> See "help caxis".
>
> Michael.
>
>
> On Mon, Jun 16, 2008 at 12:50 AM, Janmaat, John <address@hidden> wrote:
>>
>> On Sun, Jun 15, 2008 at 1:36 PM, Janmaat, John <address@hidden> wrote:
>>> Hello Ben,
>>>
>>> Thank-you. I was under the mistaken impression that zlim was a property,
>>> rather than a function. I used it, and it nicely cuts off the mesh, but
>>> does not stop the face color.
>>
>> Maybe you're also looking for "clim"?
>> I'm not sure what you mean with "does not stop the face color".
>>
>> The mesh stops at the limits set in zlim. The color sheet - composed of the
>> mesh faces I'm guessing - continues on farther, to the limits of the box in
>> which the figure is plotted.
>>
>> John.
>>
>> Michael.
>>
>>
>
>
- Jhandles axes ranges, Janmaat, John, 2008/06/14
- Re: Jhandles axes ranges, Ben Abbott, 2008/06/14
- RE: Jhandles axes ranges, Janmaat, John, 2008/06/15
- Re: Jhandles axes ranges, Michael Goffioul, 2008/06/15
- RE: Jhandles axes ranges, Janmaat, John, 2008/06/15
- Re: Jhandles axes ranges, Michael Goffioul, 2008/06/16
- RE: Jhandles axes ranges, Janmaat, John, 2008/06/16
- Re: Jhandles axes ranges,
Michael Goffioul <=