[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: about simulation...
From: |
Paul Kienzle |
Subject: |
Re: about simulation... |
Date: |
Mon, 23 Feb 2004 19:27:37 -0500 |
There are some problems with some versions of octave
on some versions of windows. Anytime octave needs to
fork to run an operating system command it freezes. I
don't see any of these in a quick look at step and rlocus,
however, there are lots of support routines I didn't look at.
If the commands you are running outputs to the pager, then
then it might freeze. Do you get lots of output? Are you
running on Windows 9x?
I believe the octave-2.1.50a version at octave-forge
(http://octave.sf.net) has fewer problems with freezing.
Hope that helps,
Paul Kienzle
address@hidden
On Feb 23, 2004, at 11:00 AM, andres felipe rendon wrote:
First question: whenever I use some commands, e.g. 'step' or 'rlocus'
my PC is freezed for a while and it won't work again until the
computation is done; is there any chance to make some changes in the
configuration in order to avoid this? (I installed it in an old
Pentium 3 550MHz with 218M RAM).
-------------------------------------------------------------
Octave is freely available under the terms of the GNU GPL.
Octave's home on the web: http://www.octave.org
How to fund new projects: http://www.octave.org/funding.html
Subscription information: http://www.octave.org/archive.html
-------------------------------------------------------------