[Gnucap-devel] gnucap sandbox

[Patrick Mulder]

Hi Felix

i tried to run some commands with gnucap today.

1) i want to save all data from a simulation session into a csv file. i
thought it would be nice to have a command csv "data.csv" - from there it
would be possible to do some plots (with e.g. xls or matplotlib). i got a
basic command working, but not sure where to take the data from

2) on the gnucap python i saw a statement "set lang verilog" - where would
i start to so some basic verilog commands (wire, register, simple gates on
event) ?

Thanks a lot!

Patrick