Re: [Geiser-users] Using multiple REPLs from elisp

[Michael Gauland]

Jose A. Ortega Ruiz <address@hidden> writes:


> Geiser associates buffers to REPLs by setting a local variable in the
> scheme buffer, geiser-repl--repl, so in principle it shouldn't be
> necessary to maintain a separate table is that variable is set for the
> buffer at hand.  When you do a switch-to-geiser from a scheme buffer,
> that variable is set automatically, possibly after creating the REPL.
> 
> Afterwards, all evaluation commands defined in geiser-mode.el use that
> variable to choose to which REPL the code is sent.  So, in principle, if
> you call commands defined in geiser-mode.el (in the section ;;Evaluation
> Commands) things should work out of the box without any additional
> book-keeping on your side.

Thanks--that gives me a good place to start.

This process may be complicated by the way babel works. Each block is evaluated
from its own temporary buffer, so the source buffer for which a REPL was
initially created may no longer exist when I go to use it again.

--Mik