[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Gcl-devel] #n= syntax
|
From: |
Camm Maguire |
|
Subject: |
[Gcl-devel] #n= syntax |
|
Date: |
Wed, 23 Aug 2017 14:08:49 -0400 |
Greetings! The ansi-spec describes n as an unsigned decimal, but all
lisp printers I have seen start n at 1. Is there any problem starting it
at 0?
Take care,
--
Camm Maguire address@hidden
==========================================================================
"The earth is but one country, and mankind its citizens." -- Baha'u'llah
- [Gcl-devel] #n= syntax,
Camm Maguire <=