|
From: | Ian Thompson |
Subject: | [Fab-user] put leaves 0 byte length files |
Date: | Mon, 3 Jul 2017 15:00:40 +0000 |
Apologies if this has already been addressed and I haven’t searched the archives enough. I’m using … Fabric3 1.13.1.post1 Paramiko 2.2.1 to update and maintain a set of 36 copper networked embedded Linux boards. Generally all works well but occasionally a parallel “put” of a file ~ 30kbytes will indicate no errors but some boards will end up with a zero byte file. Usually it’s a block of four or five boards with consecutive ip addresses that
fails but not necessarily the same block. Has this been seen before? How would I go about debugging this? Regards Ian T. |
[Prev in Thread] | Current Thread | [Next in Thread] |