RE: projectcenter launch error Windows10

[James d'Authreau]

Thanks, the binaries were directly from the windows installer, and yes the
shell was gnustep. I am not sufficiently advanced to know what "plparse" or
"defaults read" are, but if I just type them in I get "command not found"
and nothing for the other.   I wondered if this was a windows 10 thing.

-----Original Message-----
From: Riccardo Mottola [mailto:riccardo.mottola@libero.it] 
Sent: 19 November 2015 22:47
To: James d'Authreau; discuss-gnustep@gnu.org
Subject: Re: projectcenter launch error Windows10

Hi,

James d'Authreau wrote:
>
> I have installed the latest windows binaries in the right order on 
> windows 10, the shell  launches, but I can't launch projectcenter, I 
> get an error:
>

Which binaries did you install? where from? You are using the "gnustep" 
shell, right? e.g. you can type "plparse" or "defaults read" and it will
exist, execute and work?

> Projectcenter.exe Entry point not found
>
> The procedure entry point __gxx__v0 could not be located in the 
> dynamic link library c:\GNUstep\bin\libicuuc46.dll (this file is 
> actually present)
>
> Gorm doesn't launch either but with different error message:
>
> System error
>
> The program can't start because gnusetup-base-1_18.dll is missing from 
> your computer.... (not actually present)
>

I fear that ProjectCenter and Gorm were not compiled against the same 
version of gnustep and mingw libraries you are running them against.
Did you try SystemPreferences?
Sadly, there are no other apps to test... ready packaged that is.

Adam, what's your stake ? I think you did them.

Riccardo