[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] TX time control
From: |
Yeo Jin Kuang Alvin (IA) |
Subject: |
Re: [Discuss-gnuradio] TX time control |
Date: |
Tue, 15 May 2018 05:05:58 +0000 |
Hi,
Alright! I was thinking of using square wave and a multiplier but the duty
cycle is 50%, I don't know how to change it.
If I am sending a sine wave using signal source connected to the sink, how can
I send in zero's after 2s for example? Is there any time control or variable I
can use?
Thank you in advanced!
-----Original Message-----
From: address@hidden [mailto:address@hidden
Sent: Tuesday, 15 May 2018 12:56 PM
To: Yeo Jin Kuang Alvin (IA)
Cc: address@hidden
Subject: Re: [Discuss-gnuradio] TX time control
On Mon, May 14, 2018 at 08:13:13AM +0000, Yeo Jin Kuang Alvin (IA) wrote:
> I would like to transmit for an amount of samples/seconds, and stop
> transmitting for another few seconds and then transmit again. Example,
> transmit 2s, stop for 3s and then transmit for 2s and rinse and repeat.
You could try sending zero's into your sink block. That will effectively cause
your radio to cease transmitting without actually turning it off.
BW