Re: [Discuss-gnuradio] Signal Processing Block with Control Port

[Benny Alexandar]

Hi,

I'm not sure about control port, you are asking for sending asynchronous input to blocks.  GNU Radio blocks shud support data as well as control ports, which will be of much use.

-ben

--------------------------------------------------------------------------------------

Hi,

Is it possible to make a signal processing block which contains two input ports, one is byte type and the other is complex type. The only output port is also complex type. The byte type input port would just act like a controller port that when it receives "1", it allows data to flow form input complex port to output complex port.

If it is not possible, is there any alternative way to do this job in gnuradio companion?