Re: [Discuss-gnuradio] Energy Detection output incorrect

[West, Nathan]

You can use the qt gui vector plot to plot a vector. That means removing the stream to vector block. You might have to add "vector" modes to some blocks to do the other operations you want.

On Wed, Sep 20, 2017 at 6:31 PM, Tellrell White <address@hidden> wrote:

Hello Marcus

You are absolutely correct. Is there an existing sink that would allow me to display avg power given some threshold ?

Tellrell

On Wednesday, September 20, 2017 5:54 PM, Marcus Müller <address@hidden> wrote:

Hi Tellrell!

Why should both plots show the same? You send in completely different signals!

Best regards,

Marcus

On 09/20/2017 09:27 AM, Tellrell White wrote:

Hello All

I'm working on a project involving signal detection of an IEEE 802.15.4 waveform using energy detection.
The algorithm for energy detection goes as follows:

          A/D conversion ->  FFT -> mag^2 -> (1/N) ^ M -> threshold comparison

Currently, I'm doing simulations in gnuradio companion with a focus of just trying to construct the the algorithm and get an output. Below I've attached the current flowgraph i'm using along with screen shots of the flowgraph and the outputs from the fft sinks.

In the flowgraph i'm using gaussian noise as my source. I send this noise to both an FFT sink and also through the energy detection algorithm. My expectation is that both sinks will give me the same result, however, the output coming from the algorithm doesn't match the other sink and I'm currently now sure why this is. Are there some blocks I'm currently missing and/or is the FFT sink an incorrect way of trying to display the power coming from the energy detection algorithm?

Any suggestions are welcome.

Regards

Tellrell

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio