Re: [Discuss-gnuradio] Is there any gnuradio block that will repeat two file sources a fixed number of times and is variable?

[Martin Braun]

Craig,

you might just want to read the files into Python and then use vector
sources to generate any kind of signal you like.

Cheers,
M

On 08/18/2016 07:49 AM, Swanson, Craig wrote:
> ​Marcus,
> 
> I have two file sources: pulse and no pulse (noise)
> 
> 
> I want to use an interleaver to send a pulse file and then after that
> just noise.
> 
> But the interleaver will alternate file sources evenly.
> 
> 
> I want to setup a parameter that allows the combination to vary.  Maybe
> one time send five pulses, then three no pulses.  Then when I run the
> python file again, send two pulses alternating with five no pulses.
> 
> 
> Do you have a block like that?
> 
> 
> Craig
> 
> 
> *Craig F. Swanson*
> */Research Engineer II
> /*
> */Information and Communications Laboratory/*
> */Communications, Systems, and Spectrum Division/*
> /Georgia Tech Research Institute/
> /Room 560
> 250 14th St NW
> /
> /Atlanta, GA 30318/
> /Cell: 770.298.9156/
> http://www.gtri.gatech.edu
> <https://mail.gtri.gatech.edu/owa/redir.aspx?C=c20925f2f0af4dd29329ddf0701ecfff&URL=http%3a%2f%2fwww.gtri.gatech.edu%2f>
>  
>