|
From: | Yan Huang |
Subject: | [Discuss-gnuradio] Stepping and Tuning USRP Source |
Date: | Tue, 16 Feb 2016 19:01:04 +0000 |
Hi all, I want to ask some questions about gnuradio: 1.I want to use UHD: USRP Source to receive signal with 60MHz bandwidth, and I divide it into 30 channels, and each time the usrp source receive 2MHz bandwidth signal, and then improve the center frequency
with step=1.5MHz. I know I need to set the USRP center frequency as: uhd.tune_request(center_freq, rf_freq=(center_freq + lo_offset),rf_freq_policy=uhd.tune_request.POLICY_MANUAL) But I don’t know how to change the center frequency from the min_frequency to max_frequency with each step. 2.And then I connect the USRP source ->steam to vector->FFT->vector to stream->file sink, if FFT length is 256, sample rate is 2MHz, the sample number in the file sink is also 256(if I use overwite)? If
not, how many number is in the file sink? Is anybody familiar with these? Thanks in advance. Best Regards, Yan This message and any attachment are intended solely for the addressee and may contain confidential information. If you have received this message in error, please send it back to me, and immediately delete it. Please do not use, copy or disclose the information contained in this message or in any attachment. Any views or opinions expressed by the author of this email do not necessarily reflect the views of the University of Nottingham. This message has been checked for viruses but the contents of an attachment may still contain software viruses which could damage your computer system, you are advised to perform your own checks. Email communications with the University of Nottingham may be monitored as permitted by UK legislation. |
[Prev in Thread] | Current Thread | [Next in Thread] |