Re: [Discuss-gnuradio] Losing sample count integrity / Source(s) slipping ?

[Tom McDermott]

After some further investiagation, it appears that this may be a slow, long term

analog drift in the cosine wave source (perhaps due to single precision math?). The

voltage values aren't the same at each point in the waveform - they slowly drift
over many minutes of computer runtime.

-- Tom, N5EG

On Fri, Dec 4, 2015 at 3:48 PM, Tom McDermott <address@hidden> wrote:

In working on some waveform sampling tests, have encountered an apparent drift

between two gnuradio sources that are run at the same rate.  I've tried to structure

the flowgraph so that the QT GUI does not get involved in the exact sample count

integrity between two flow graph paths. 

The attached flowgraph constructs a sampling pulse near the zero-crossing time of

the cosine wave, then displays that sampled analog value.  Over time, the cosine

source appears to be slipping in time compared to the square wave source. The

analog sampling pulse samples the cosine source 'near' the zero crossing. But with

increasing run-time of the flow graph, it appears to be drifting off. I'm at a loss to
explain this.

Attached is the simplest GRC flowgraph that demonstrates the effect.  It needs to
run for a few tens of seconds before the analog sampled value starts to grow.

The time sample at 6 milliseconds is the sampled analog value.  Even if it's not exactly
zero, it should remain relative stable in analog value.

Any advice on what I might be doing wrong here?

-- Tom, N5EG