Make sure you put an attenuator before going back into the N200 so that you do not damage the RF input.
Ruben
From: discuss-gnuradio-bounces+address@hidden [mailto:discuss-gnuradio-bounces+address@hidden
On Behalf Of Carlos Alberto Ruiz Naranjo
Sent: Friday, October 17, 2014 3:35 PM
To: address@hidden
Subject: [Discuss-gnuradio] TX/RX with USRPN200 and GNURadio
Hello,
I want to transmit and receive at the same time with WBX board and USRPN200. I have this flowgraph.
I connected the input and output with a RF cable (a loop).
Is it possible? Is there any problem?
Thank you.