Re: [Discuss-gnuradio] grc-mimo setup

[Mike Jameson]

Your device hint in the 'Device Addr' section of the 'UHD Source' block should be "addr=192.168.10.2" and in a separate 'UHD source' block the "Device Addr" should be "addr=192.168.10.3"

Mike

--
Mike Jameson M0MIK BSc MIET
Ettus Research Technical Support
Email: address@hidden
Web: http://ettus.com

On Thu, May 15, 2014 at 1:39 PM, xianda <address@hidden> wrote:

 Hello all:
               Environment: 2 usrp N210,mimo cable(they connect with each other and share the Ethernet)
              
               And i use the gnuradio companion to set up a very simple example.And the example is attached on the email.And I run this simple example,an error comes:
              RuntimeError: ValueError: Could not resolve device hint "" to a single device.
 
              And ping 192.168.10.2 and ping 192.168.10.3,it's all ok.
              Can someone help me to solve it?Thank you very much.
Best regards

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio