Re: [Discuss-gnuradio] Time delaying a signal

[Martin Braun]

On 13.05.2014 07:14, asad umer wrote:
> I am also  using the delay block in the way u have mentioned but the
> signal in scope doesn't act accordingly ,it remains in phase with the
> original...

That's unlikely. Do this:

1) Connect sig source into port 1 of your scope (e.g. create a sine wave)
2) Connect same sig source to delay
3) Connect delay to port 2 of your scope
4) Choose a good delay that's not multiples of your "wave length"
5) Et voilá, phase shift.

M