|
From: | Syed Aqeel Raza |
Subject: | [Discuss-gnuradio] Fwd: Video Streaming Issue (most probably at receiving end) |
Date: | Mon, 3 Feb 2014 23:54:12 +0800 |
Hi Martin,Thanks for your reply.I have made some changes in the flowgraphs due to which the transmitter and receiver sides handshakes with each other. Despite of this handshaking, the receiver side is not produced the required baseband signal. Furthermore, I have designed a single flowgraph that comprises on transmitter and receiver without the inclusion of USRP source and sink block. That single flowgraph works fine and perfectly streaming the video.I will send the updated flowgraphs to you by tomorrow.Regards,Syed Aqeel RazaOn Sat, Feb 1, 2014 at 8:05 PM, Martin Braun <address@hidden> wrote:
On 30.01.2014 18:17, Syed Aqeel Raza wrote:How did you test the transmitter?
I have checked the transmission part, which is working perfectly by
transmitting a video stream over the wireless. Whereas, no video
reception is displayed on receiver end.
There's many things that can go wrong here. Does your rx spectrum look good?
For further reference, I have attached the flow charts used for
transmission and reception of video streaming. An earliest reply is
highly appreciated.
MB
vdo transmission.png
Description: PNG image
gmsk_file_transceiver.grc
Description: application/gnuradio-grc
gmsk_tx.grc
Description: application/gnuradio-grc
gmsk_rx.grc
Description: application/gnuradio-grc
[Prev in Thread] | Current Thread | [Next in Thread] |