Re: [Discuss-gnuradio] Adding block to an existing module

[Martin Braun]

On Fri, May 25, 2012 at 01:48:55PM +0200, Piotr Palka wrote:
> I have built a new module using the create-gnuradio-out-of-tree-project
> command. Now I would like to add new blocks to this module. Writing new .h, 
> .cc
> and swig-files is not a problem, but obviously I have to adapt some Makefiles
> etc.
> 
> I thought, it would be a good idea to take a look at the howto-write-a-block
> structure and modify existing Makefiles. But I am not familiar with these
> things and hope there is an easier way.
> 
> Could someone please tell me, what is the best way to add a signal processing
> block to an existing module? At the moment I am only able to create a new 
> block
> creating a new module at the same time, which doesn’t make much sense. I have
> searched the web a lot, maybe it is too trivial to find any useful 
> information…

Using gr-modtool would be the easiest way.
(https://www.cgran.org/wiki/devtools). 

And it's not *that* hard to find.

MB


-- 
Karlsruhe Institute of Technology (KIT)
Communications Engineering Lab (CEL)

Dipl.-Ing. Martin Braun
Research Associate

Kaiserstraße 12
Building 05.01
76131 Karlsruhe

Phone: +49 721 608-43790
Fax: +49 721 608-46071
www.cel.kit.edu

KIT -- University of the State of Baden-Württemberg and
National Laboratory of the Helmholtz Association

pgpheOu7GT5BD.pgp
Description: PGP signature